недоступно на русском языке

Тезис Предпросмотр

This document describes a laboratory test method, using an IGT1-type or a prüfbau2-type printability tester, for the preparation of specimens to evaluate the absorption rate of an ink on a substrate in offset lithography by setting-off the printed surface to an unprinted surface.

This method describes testing with an amount of ink simulating either single colour or multi-colour printing. The print and the set-off print (counter print) are made with interval times, between print and set-off, common for the target process.

This method evaluates a particular ink and substrate combination.

 

1These materials are available from IGT Testing Systems, www.igt.nl. This information is given for the convenience of the users of this document and does not constitute an endorsement by ISO of the products. Equivalent products may be used if they can be shown to lead to the same results.

2These materials are available from prüfbau, Dr.-Ing. H. Dürner GmbH, www.pruefbau.de. This information is given for the convenience of the users of this document and does not constitute an endorsement by ISO of the products. Equivalent products may be used if they can be shown to lead to the same results.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2021-06
  • Версия : 1
  • :
    ISO/TC 6/SC 2
    Test methods and quality specifications for paper and board
  • 85.060
    Paper and board
    87.080
    Inks. Printing inks
    37.100.20
    Materials for graphic technology

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF118

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.