недоступно на русском языке

Тезис

 Предпросмотр

This document specifies requirements for 13 grades of cut steel wire abrasives, as supplied for blast-cleaning processes. It specifies ranges of particle sizes, together with corresponding grade designations. Values are specified for hardness, density, defect/structural requirements, metallographic structure and chemical composition.

This document is suitable for cut steel wire supplied for blast-cleaning processes which is made by cutting new cold drawn wire.

The requirements specified in this document apply to abrasives manufactured from virgin wire supplied in the new and unconditioned state only. They do not apply to abrasives either during or after use.

NOTE 1 Information on commonly referenced national standards for cut steel wire abrasives and their approximate relationship with ISO 11124 is given in Annex A.

NOTE 2 Although this document has been developed specifically to meet requirements for preparation of steelwork, the properties specified will generally be appropriate for use when preparing other material surfaces, or components, using blast-cleaning techniques.


Общая информация 

  • Текущий статус
     :  Published
    Дата публикации
     : 2019-06
  • Версия
     : 1
  • Технический комитет
     : ISO/TC 35/SC 12 Preparation of steel substrates before application of paints and related products
  • ICS
     :
    25.220.10 Surface preparation

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF61

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.

  2. Интернет-магазин
  3. Каталог стандартов
  4. ТК
  5. ISO/TC 35/SC 12
  6. ISO 11124-5:2019