Electronic fee collection -- Charging performance -- Part 2: Examination Framework
This standard has been revised by ISO/TS 17444-2:2017
ISO/TS 17444-2:2013 defines the Examination Framework for the measurement of Charging Performance Metrics defined in ISO/TS 17444-1 to be used during Evaluation and/or on-going Monitoring.
It specifies a method for the specification and documentation of a Specific Examination Framework which can be used by the responsible entity to evaluate charging performance for a particular information exchange interface or for overall charging performance within a Toll Scheme.
It provides a toolbox of Examination Tests for the roles of Toll Charger and Toll Service Provider for the following Scheme types:
- DSRC Discrete;
- Autonomous Discrete;
- Autonomous Continuous.
The detailed choice of the set of examination tests to be used depends on the application and the respective context. Compliance with ISO/TS 17444-2:2013 is understood as using the definitions and prescriptions laid out in ISO/TS 17444-2:2013 whenever the respective system aspects are subjected to performance measurements, rather than using other definitions and examination methods than the ones specified in ISO/TS 17444-2:2013.
Out of scope of ISO/TS 17444-2:2013 are the following aspects:
- ISO/TS 17444-2:2013 does not propose specific numeric performance bounds, or average or worst-case error bounds in percentage or monetary units. Those decisions are left to the Toll Charger (or to agreements between Toll Charger and Service Provider).This Technical Specification does not consider the evaluation of the expected performance of a system based on modelling and measured data from trial at another place.
- ISO/TS 17444-2:2013 does not consider the specification of a common reference system which would be required for comparison of performance between systems.
- ISO/TS 17444-2:2013 defines measurements only on standardised interfaces. Proprietary interfaces are excluded, because it is not possible to define standardised metrics on such system properties. These excluded interfaces are among others the link between Toll Charger RSE and central systems in DSRC systems, and the additional sensor input of GNSS modules (inertial sensors, CAN-bus for wheel ticks, etc.).
A standard is reviewed every 5 years
Revisions / Corrigenda