This standard was last reviewed and confirmed in 2012. Therefore this version remains current.
This standard gives requirements and test methods for rubber and plastics suction hoses for fire-fighting purposes.
NOTE 1 All pressures are expressed in megapascals. 1 MPa = 10 bar.
Additional requirements are specified for hose assemblies, that is, hoses with couplings already fitted, where this is carried out by the hose manufacturer (see clause 8).
Type A (Rubber) hoses are intended for use at a minimum temperature of -20 _ C and Type B (Thermoplastics) hoses are intended for use at a minimum temperature of -10 _ C.
NOTE 2 Hoses for use at temperatures lower than those specified above can be supplied by agreement between the manufacturer and purchaser. In this case, the low temperature flexibility test (see 6.3) should be carried out at the specified temperature.
RTF report excerpt
! RTF: element uses bad font `MSTT31C69400´ with content ...m temperature of -20'_ 'C and Type B (Thermo...
! RTF: element uses bad font `MSTT31C69400´ with content ...m temperature of -10'_ 'C....
Status : PublishedPublication date : 2002-12
Edition : 1Number of pages : 18
Technical Committee:Rubber and plastics hoses and hose assemblies
Buy this standard