ISO 4437-1:2026

Вы можете ознакомиться с данным стандартом в нашей онлайн-библиотеке (OBP)

недоступно на русском языке

Опубликовано (Версия 3, 2026)

ISO 4437-1:2026

CHF 135

Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This document specifies materials and the general aspects of polyethylene (PE) piping systems in the field of the supply of gaseous fuels.

NOTE For the purpose of this document, the term gaseous fuels includes, for example, natural gas, methane, butane, propane, hydrogen, manufactured gas, biogas, and mixtures of these gases.

This document also specifies the test parameters for the test methods referred to in this document.

In conjunction with ISO 4437-2, ISO 4437-3, ISO 4437-4 and ISO 4437-5, this document is applicable to PE pipes, fittings and valves, their joints, and joints with components of PE and other materials intended to be used under the following conditions:

a maximum operating pressure (MOP) up to and including 10 bar¹⁾, at a design reference temperature of 20 °C;
an operating temperature between −20 °C and 40 °C.

For operating temperatures between 20 °C and 40 °C, derating coefficients are specified in ISO 4437-5.

The ISO 4437 series covers a range of MOPs and gives requirements concerning colours.

It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national guidance or regulations and installation practices or codes

¹⁾1 bar = 0,1 MPa = 10⁵ Pa; 1 MPa = 1 N/mm².

Общая информация

Текущий статус
: Опубликовано

Дата публикации
: 2026-10

Этап
: Опубликование международного стандарта [60.60]
Версия
: 3
Технический комитет :
ISO/TC 138/SC 4

ICS :
75.200 83.140.30
RSS обновления