недоступно на русском языке

Тезис Предпросмотр

This document specifies a laboratory method for measuring the vibration at the handle of fastener driving tools. It is a type test procedure for establishing the vibration value on the handle of a hand-held power tool operating under a specified load.

This document is applicable to fastener driving tools driven pneumatically or by other means, using nails, staples or pins.

This document is applicable to tools with single sequential actuation, contact actuation, contact actuation with automatic reversion or continual contact actuation (see Figures 1 to 3).

This document is not applicable to tools operating in full sequential mode due to their much longer intervals in between individual actuations. However, to provide an indication for comparison of different tools of this type (see Figures 4 and 5), Annex C provides informative guidance.

NOTE       Today current knowledge does not allow any conclusions regarding physiological and pathological effects between isolated shocks and continuous shock sequences, and their repetition rates.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2022-02
  • Версия : 1
  • :
    ISO/TC 118/SC 3
    Pneumatic tools and machines
  • 13.160
    Vibration and shock with respect to human beings
    25.140.10
    Pneumatic tools

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития:

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF118

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.