ISO 11297-3:2018 Предпросмотр

Plastics piping systems for renovation of underground drainage and sewerage networks under pressure -- Part 3: Lining with close-fit pipes

недоступно на русском языке

This document, in conjunction with ISO 11297‑1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of underground drainage and sewerage networks under pressure.

It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to polyethylene (PE) pipes of either solid wall single layer or co-extruded layer construction, which is reduced in the factory or on site to provide a close-fitting independent or interactive pressure pipe liner, as well as associated fittings and joints for the construction of the lining system. It is not applicable to PE coated pipes having a peelable, contiguous, thermoplastic additional layer on the outside of the pipe.

It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature.

NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see ISO 4427‑1:2007, Annex A.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2018-09
  • Версия : 2
    Число страниц : 16
  • :
    ISO/TC 138/SC 8
    Rehabilitation of pipeline systems
  • 23.040.45
    Plastics fittings
    23.040.20
    Plastics pipes
    91.140.80
    Drainage systems
    93.030
    External sewage systems

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF88

Жизненны цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах

 Subscribe