ISO 13363:2016

Последний раз этот стандарт был пересмотрен в 2021. Поэтому данная версия остается актуальной

Тезис

ISO 13363:2016 specifies requirements for three types and two classes of hose. The hoses are intended for use in marine-engine wet-exhaust systems (where the exhaust gases are mixed with the discharge of cooling water). It does not apply to outboard motor/personal water craft.

The three types are the following:

- type 1: a softwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement;

- type 2: a hardwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement with a helical wire embedded in it;

- type 3: a hose or tube (flexible connector), made of oil-resistant material, with or without a reinforcement or cover, intended for use in short lengths in locations where the connector is protected from mechanical damage.

The two classes are the following:

- class A: intended for diesel engines;

- class B: intended for petrol engines and for diesel engines with a very high exhaust temperature.

Общая информация

Текущий статус
: Published

Дата публикации
: 2016-01
Версия
: 2
Технический комитет
: ISO/TC 45/SC 1 Rubber and plastics hoses and hose assemblies
ICS
:
47.080 Small craft

83.140.40 Hoses