ISO 21307:2017 Предпросмотр

Plastics pipes and fittings -- Butt fusion jointing procedures for polyethylene (PE) piping systems

недоступно на русском языке

ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are:

- single low-pressure fusion jointing procedure;

- dual low-pressure fusion jointing procedure;

- single high-pressure fusion jointing procedure.

ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2017-12
  • Версия : 3
    Число страниц : 16
  • :
    ISO/TC 138/SC 4
    Plastics pipes and fittings for the supply of gaseous fuels
  • 23.040.20
    Plastics pipes
    23.040.45
    Plastics fittings
    75.200
    Petroleum products and natural gas handling equipment
    93.025
    External water conveyance systems

Приобрести данный стандарт

Формат Язык
PDF
Бумажный
  • CHF88

Жизненны цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах

Subscribe