Последний раз этот стандарт был пересмотрен в 2018. Поэтому данная версия остается актуальной
Тезис Предпросмотр
ISO 6520-2:2013 collects and classifies the possible imperfections in welds made with pressure. A uniform designation is specified. Only the type, shape, and dimensions of the different imperfections caused by welding with pressure are included. Metallurgical deviations are not taken into account. Imperfections produced other than by the welding operation, e.g. additional stresses, loads or environmental factors, are not covered by ISO 6520-2:2013.
Information concerning the consequences of the imperfections mentioned and the use of particular structures is not given, because this depends on the specific requirements of the joint.
Общая информация
-
Текущий статус : PublishedДата публикации : 2013-08
-
Версия : 2
-
- ICS :
-
Welded joints and welds
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF118
Жизненный цикл
-
Ранее
WithdrawnISO 6520-2:2001
-
Сейчас
PublishedISO 6520-2:2013
Стандарт, который пересматривается каждые 5 лет
Этап: 90.93 (Подтверждено)
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.