Последний раз этот стандарт был пересмотрен в 2017. Поэтому данная версия остается актуальной
Тезис Предпросмотр
ISO 15530-3:2011 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured.
Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and interim check of the measurement uncertainty.
Общая информация
-
Текущий статус : PublishedДата публикации : 2011-10
-
Версия : 1
-
Технический комитет:Dimensional and geometrical product specifications and verification
-
- ICS :
-
Measuring instruments
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF88
Жизненный цикл
-
Ранее
WithdrawnISO/TS 15530-3:2004
-
Сейчас
PublishedISO 15530-3:2011
Стандарт, который пересматривается каждые 5 лет
Этап: 90.93 (Подтверждено)
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.