Последний раз этот стандарт был пересмотрен в 2017. Поэтому данная версия остается актуальной
Тезис Предпросмотр
ISO 18286:2008 specifies requirements for tolerances for hot-rolled stainless steel plates (quarto plates) made on a reversing mill with the following characteristics: nominal thickness, t, from 4 mm to 250 mm; and nominal width, w, equal to or greater than 600 mm.
Tolerances for plate of width w less than 600 mm cut or slit from wider plate should be agreed upon between manufacturer and purchaser at the time of enquiry and order.
ISO 18286:2008 is not applicable to round plates, custom-made plates, checker plate or bulb plate for flooring or wide flats, nor to continuous-process plates (plate made with coiling).
Общая информация
-
Текущий статус : PublishedДата публикации : 2008-12
-
Версия : 2
-
- ICS :
-
Flat steel products and semi-products
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF58
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.