Тезис Предпросмотр

ISO 4080:2009 specifies three methods for the determination of the volume of gas diffusing through a rubber or plastics hose or length of tubing in a specified time.

  • Method 1: For determining the permeability of the complete hose or length of tubing, excluding end-fittings, to the test gas. The permeability is calculated with respect to the length of the hose or tubing.
  • Method 2: For determining the permeability at the hose/fitting interface. This method is used when determining the permeability characteristics of hoses with an unpricked cover, when the gas usually issues from the textile reinforcement at the cut ends. The permeability is calculated with respect to the length of the hose.
  • Method 3: For determining precisely the permeability of a hose or hose assembly to the test gas. The permeability is calculated with respect to the surface area of the hose lining.

The methods are applicable only to gases which are insoluble in water.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2009-12
  • Версия : 4
    Число страниц : 8
  • :
    ISO/TC 45/SC 1
    Rubber and plastics hoses and hose assemblies
  • 23.040.70
    Hoses and hose assemblies

Приобрести данный стандарт

Формат Язык
PDF
Бумажный
  • CHF58

Жизненны цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах