недоступно на русском языке

Тезис Предпросмотр

ISO 23228:2011 specifies a method for the determination of the time-to-failure of thermoplastics resins and compounds for piping and fitting applications by the use of a plane strain grooved tensile specimen in a stress-rupture test.

The grooved tensile specimen produces a biaxial state of stress on uni-axial loading, which is taken to be indicative of the stress conditions found in pressurized solid-wall plastics pipes. The ratio of the stress in the axial direction to the transverse direction approximates that for a pressurized end-capped solid-wall pipe specimen.

It is intended that the data generated on these specimens be utilized to determine the stress-rupture (time-to-failure) resistance of moulding materials for pipes and fittings as well as experimental piping resins.

This method is also applicable to stress-rupture evaluations of pipes which are difficult to test, e.g. larger diameter pipes, including their batch release tests.

ISO 23228:2011 is not intended to replace the stress-rupture test of ISO 1167, which uses internally pressurized end-capped pipes.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2011-10
  • Версия : 1
    Число страниц : 9
  • :
    ISO/TC 138/SC 5
    General properties of pipes, fittings and valves of plastic materials and their accessories -- Test methods and basic specifications
  • 23.040.20
    Plastics pipes

Приобрести данный стандарт

Формат Язык
PDF
Бумажный
  • CHF58

Жизненны цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

  • Не подтверждено
    ISO 23228:2011

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах