Тезис 

ISO 10816-4:2009 establishes specific provisions for evaluating the severity of in-situ, broad-band vibration measured radial (i.e. transverse) to the shaft axis on all main bearing housings or pedestals and in the axial direction on thrust bearings. These are in terms of:

- vibration under normal steady-state operating conditions;

- vibration during other (non-steady-state) conditions when transient changes are taking place, including run up or run down, initial loading and load changes;

- changes in vibration which can occur during normal steady-state operation.

ISO 10816-4:2009 is applicable to heavy-duty gas turbine sets used in electrical and mechanical drive applications, with fluid-film bearings, outputs greater than 3 MW and an operating speed range under load between 3 000 r/min and 30 000 r/min.


Общая информация

  • Текущий статус :  Withdrawn
    Дата публикации : 2009-10
  • Версия : 2
  • Технический комитет
    :
    ISO/TC 108/SC 2
    Measurement and evaluation of mechanical vibration and shock as applied to machines, vehicles and structures
  • ICS :
    17.160
    Vibrations, shock and vibration measurements
    27.040
    Gas and steam turbines. Steam engines

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 17
  6. 17.160
  7. ISO 10816-4:2009