Тезис 

Applies to products produced in thicknesses of 1,6 mm and over and widths of 600 mm and over, in coils and cut lengths. Hot-rolled sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet. Specifies conditions of manufacture (steelmaking, chemical composition, chemical analysis, weldability, application, mechanical properties, surface condition), dimensional tolerances, sampling, mechanical property test (tensile test, impact test), retests, resubmission, workmanship, inspection and acceptance, coil size, information to be supplied by the purchaser. Annex A gives information on fabricability.


Общая информация

  • Текущий статус :  Withdrawn
    Дата публикации : 1993-10
  • Версия : 2
  • :
    ISO/TC 17/SC 12
    Continuous mill flat rolled products
  • 77.140.50
    Flat steel products and semi-products

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.