New ISO standards lift the safety level of cranes worldwide

Время на чтение: Несколько минут

Эта новость из нашего архива

Опубликован на
Поделиться , ,

ISO 23814:2009, Cranes – Competency requirements for crane inspectors, specifies the competency required of persons who carry out periodic, exceptional, alteration and thorough inspections of cranes. It excludes the day-to-day inspection and checks performed by crane operators and maintenance personnel. The standard addresses the following issues:

  • Independence, impartiality and integrity
  • Technical knowledge and experience
  • Techniques for crane inspection
  • Training of crane inspectors.

The objective of this International Standard is to achieve a uniformly high competency of crane inspectors worldwide. In some countries, there may be additional regulatory requirements that must also be taken into account.

Two other standards point out that to ensure cranes are operated safely, their proper working and operational conditions need to be maintained. Therefore, all cranes require to undergo inspections to detect deviations from safe conditions so they can be put right. The inspections are the responsibility of crane users or owners.

ISO 9927-1:2009, Cranes – Inspections – Part 1: General specifies the inspections to be carried out on cranes, excluding inspections carried out prior to first use.

It covers:

  • Inspection
  • Methods of inspection
  • Inspection personnel,
  • Precautions for inspection,
  • Results of inspection.

ISO 9927-3:2005, Cranes – Inspections – Part 3: Tower cranes specifies the regular inspections to be carried out on tower cranes:  

  • Daily inspections
  • Frequent inspections
  • Periodic inspections
  • Thorough inspections.

Cranes are used worldwide in the construction, manufacturing and transportation industries wherever the safe lifting and moving of loads is required. The progressive introduction of new International Standards and the regular review of existing ones will have a direct and positive effect on general safety by reducing potential hazards, as well as helping to remove technical barriers to the international trade in cranes.

Actively involved in the elaboration of these standards are multi-national and national manufacturers, users, inspection bodies, institutions for higher education, insurance companies and government health and safety organizations from all five continents.

ISO 9927-1:2009, ISO 9927-3:2005 and ISO 23814:2009 were developed by ISO technical committee ISO/TC 96, Cranes, subcommittee SC 5, Use, operation and maintenance.

ISO 9927-1:2009, Cranes – Inspections – Part 1: General, ISO 9927-3:2005, Cranes – Inspections – Part 3: Tower cranes and ISO 23814:2009, Cranes – Competency requirements for crane inspectors, are available from ISO national member institutes (see the complete list with contact details). They may also be obtained directly from the ISO Central Secretariat, respective prices 58, 112 and 58 Swiss francs, through the ISO Store or by contacting the Marketing & Communication department (see right-hand column).


Sandrine Tranchard
Sandrine Tranchard

+41 22 749 03 11
Контактные данные для СМИ

press@iso.org

Вы журналист, блогер или редактор?

Хотите получить информацию о стандартах из первых рук, или узнать больше о том, что мы делаем? Свяжитесь с нашей командой или ознакомьтесь с нашим медиа-китом.

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.