ISO 14521:2026

Prévisualiser cette norme sur notre Plateforme de consultation en ligne (OBP)

Indisponible en français

Publiée (Edition 1, 2026)

ISO 14521:2026

CHF 227

Convertir les francs suisses (CHF) dans une autre devise

Résumé

This document specifies formulae for calculating the load capacity of cylindrical worm gears and covers load ratings associated with wear, pitting, worm deflection, tooth breakage and temperature. Scuffing and other failure modes are not covered by this document.

NOTE 1 The load rating and design procedures are only valid for tooth surface sliding velocities, , less than or equal to 25 m/s and contact ratios greater than 2,1.

NOTE 2 For wear, load rating and design procedures are only valid for tooth surface sliding velocities which are above 0,1 m/s.

NOTE 3 The rules and recommendations for the dimensioning, lubricants or materials selected by this document only apply to centre distances of 50 mm and larger. For centre distances below 50 mm, method A applies.

is document specifies formulae for calculating the load capacity of cylindrical worm gears and covers load ratings associated with wear, pitting, worm deflection, tooth breakage and temperature. Scuffing and other failure modes are not covered by this document.

NOTE 1 The load rating and design procedures are only valid for tooth surface sliding velocities, , less than or equal to 25 m/s and contact ratios greater than 2,1.

NOTE 2 For wear, load rating and design procedures are only valid for tooth surface sliding velocities which are above 0,1 m/s.

Informations générales

État actuel
: Publiée

Date de publication
: 2026-09

Stade
: Norme internationale publiée [60.60]
Edition
: 1
Comité technique :
ISO/TC 60/SC 1

ICS :
21.200
RSS mises à jour