Reference number
ISO 4427-3:2019
© ISO 2026
International Standard
ISO 4427-3:2019
Plastics piping systems for water supply, and for drainage and sewerage under pressure — Polyethylene (PE) — Part 3: Fittings
Edition 2
2019-07

Prévisualiser cette norme sur notre Plateforme de consultation en ligne (OBP)

Indisponible en français
Publiée (Edition 2, 2019)

ISO 4427-3:2019

Langue
Format
CHF 159
* Frais d'expédition non compris
Convertir les francs suisses (CHF) dans une autre devise

Résumé

This document specifies the fittings made from polyethylene (PE) for buried or above ground applications, intended for the conveyance of water for human consumption, raw water prior to treatment, drainage and sewerage under pressure, vacuum sewer systems, and water for other purposes.

NOTE 1 The intended uses include sea outfalls, laid in water and connection between pipes suspended below bridges.

This document also specifies the test parameters for the test methods referred to in this document.

In conjunction with the other parts of the ISO 4427 series, this document is applicable to PE fittings, to joints with components of PE or other materials, intended to be used under the following conditions:

a) a maximum allowable operating pressure (PFA) up to and including 25 bar[1];

b) an operating temperature of 20 °C as the reference temperature.

NOTE 2 For other operating temperatures, guidance is given in ISO 4427‑1:2019, Annex A.

This document covers a range of maximum allowable operating pressures and gives requirements concerning colours.

NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and installation practices or codes.

This document is applicable to fittings of the following types:

1. fusion fittings;

  1. a. electrofusion fittings;
  2. b. spigot end fittings (for butt fusion using heated tools and electrofusion socket fusion);
  3. c. socket fusion fittings (see Annex A);

2. mechanical fittings;

  1. a. compression fittings;
  2. b. flanged fittings;

3. fabricated fittings (see Annex B).

[1] 1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.

Informations générales

Prochaine édition en cours d'élaboration

Draft
International Standard
ISO/DIS 4427-3
Systèmes de canalisations en plastique destinés à l'alimentation en eau et aux branchements et collecteurs d'assainissement sous pression — Polyéthylène (PE) — Partie 3: Raccords
Reference number
ISO/DIS 4427-3
Edition 1
© ISO 2026
Projet Norme internationale

ISO/DIS 4427-3

Systèmes de canalisations en plastique destinés à l'alimentation en eau et aux branchements et collecteurs d'assainissement sous pression — Polyéthylène (PE)

Partie 3: Raccords

ISO/DIS 4427-3

Langue
Format
CHF 67
* Frais d'expédition non compris
Convertir les francs suisses (CHF) dans une autre devise

Cycle de vie

Objectifs de développement durable

Cette norme contribue à l'Objectif de développement durable suivant

9
Industrie, innovation et infrastructure

Vous avez une question?

Consulter notre Aide et assistance

  2. Store
  3. Store
  4. ICS
  5. 93
  6. 93.025
  7. ISO 4427-3:2019